WATER JET CUTTING - WAMECH SERVICES

Skip to Content

WATERJET CUTTING
GOT QUESTIONS OR WANT TO GET A QUOTE? CONTACT US USING THE FORM BELOW.
Name *
E-mail address *
Message *
Processing of personal data *
I agree
I understand and accept that by sending a message via this form,
you consent to the processing of my personal data. More information
on data processing can be found in our privacy policy.
DIRECT CONTACT

Karol Duda

Junior Marketing and Contract Service Specialist
e-mail: kduda@wamech.com
phone: +48 603 925 825

WATER CUTTING SERVICES

Waterjet is an excellent choice for precise cutting with the relative low costs even during creation of single item. The cutting process is carried out by water jet with addition of abrasive – thanks to very high pressure allows to cut virtually any material. Abrasive element used during the cutting is garnet – natural mineral of silicates cluster so the whole cutting process can be called very ecological as it does not use any kind of oils or other polluting substances. Water cutting technology is a method thanks to which it is possible to cut many different materials such as: steel, aluminum, granite, marble, plastics, glass, sponge and foams, composite materials and many more.

ADVANTAGES OF WATER CUTTING

Speed of cutting and its precision – additionally supported by Intelli-MAX® system

Programmable, mechanized “Z” axis with the precise OMAX MAXJET®5i Nozzle additionally increase efficiency of cutting

The chassis is protected against water, dust and scraps of material
Computerised, dedicated station for control of the WaterJet machine

Highly efficient industry direct drive pumps abailable up to 40 hp with operating efficiences up to 85%

Intelli-VISOR® SE system simplifies routine maintenance planning to minimise downtime

waterjet wycinanie wodą

cięcie wodą wamech

cięcie wodą kraków wamech

cięcie detali wodą kraków

Rapid Water Level Control for quiet submerged cutting

Bulka Abrasive Feed Assembly transports garnet from the assembly’s large hopper into the Zero Downtime Hopper located at the Programmable Motorized Z-Axis

Does not create heat-affected zones or mechanical stresses during cutting

Does not require tools change or long setup

Lowest electrical consumption compared to other pump technology

Smooth surface of cutting material